Specifies an IP address for the network adapter using an IPv4 dot notation. This parameter is supported only on ESX/vCenter Server 4.1 and later. Indicates that the network adapter is enabled for Fault Tolerance (FT) logging. Use this parameter only if the AutoNegotiate parameter is not set. You can set this parameter only when updating a PhysicalNIC. Indicates whether the link is capable of full-duplex. For VMKernel adapters, Dhcp is supported only on ESX 4.1 and later. Indicates whether the host network adapter uses a Dhcp server. Indicates that the cmdlet is run only to display the changes that would be made and actually no objects are modified.
![vmware mac address prefix vmware mac address prefix](https://help.skytap.com/images/docs/scr-env-vmset-netadapters-edit.png)
Note that updating the speed (BitRatePerSec) of a physical NIC might take some time due to the hardware configuration being performed, and the returned object might still contain the current configuration instead of the updated one. Only valid when configuring a physical NIC. Use this parameter only if the Duplex and BitRatePerSecMb parameters are not set. Indicates that the host network adapter speed/duplex settings are configured automatically. Indicates that the IPv6 address is obtained through a router advertisement. For a console virtual NIC, you can modify the IP and the subnet mask, or choose DHCP mode. For a regular virtual NIC, you can change the IP address and the subnet mask. For a physical NIC, you can change the duplex and the bit rate settings (10, 100, 1000, 10000). Set-VMHostNetworkAdapter -VirtualNic ] ] ] ] ] ] ] ĭetailed DescriptionThis cmdlet configures the specified host network adapter. Set-VMHostNetworkAdapter -VirtualNic -PortGroup SyntaxSet-VMHostNetworkAdapter -PhysicalNic
![vmware mac address prefix vmware mac address prefix](https://i0.wp.com/wahlnetwork.com/wp-content/uploads/2013/04/vm-mac-address.png)
Set-VMHostNetworkAdapter - vSphere PowerCLI Cmdlets Reference vSphere PowerCLI Reference Set-VMHostNetworkAdapter SynopsisThis cmdlet configures the specified host network adapter.